![]() You then need to set your End Frame to approximately the mentioned 4320 and you're fine. Uncheck use_preview_range and then your End Frame in your Timeline should show 250 as well as it is now set to in your Render Properties. The 9357 are nearly 6:30 mins, so this should be reduced to about 24 frames/sec * 60 sec/min * 3 min = 4320 Frames. The 250 Frames are just 10.4 seconds (or 10 Seconds plus 10 Frames, you already stepped one frame backwards in your screenshot to 10+09) which were rendered in your case. If it's checked, your Timeline Frame Range Settings only effect Playback ( Ctrl+ A), but when you render your Movie ( Ctrl+ F12), the Render Properties Frame Range will be used (both differ in your case 9357/250). Thanks again.You can set your End Frame visually by selecting the last non-black Frame of your footage in the VSE and then hovering your mouse over the Timeline and pressing E for End Frame (as indicated in the Frame menu) or S for Start Frame to set it as your current frame (that's the green vertical line in the VSEs Sequencer View and in the Timeline).īut make sure, as in your case you did this "wrong", that you unselect the " Use an alternative start/end frame range for animation playback and OpenGL renders instead of the Render properties start/end frame range".Īs you can see in your Screenshot, you checked it: I was just wondering if there is one software I can use for both tasks - video overlay and data analysis. ![]() I checked it out but it doesn't offer any analysis, like lap by lap comparison of speed, brakes, etc. All of you have recommended Race render for video overlays. Which tool is that?Įdit: thanks for the suggestions. I have seen videos where people overlay data, track map and other measurements on top of the video. The premium version gives access to more channels and overlays video as well. ![]() I have briefly used the free version of the track attack app and it looks good in terms of analysis (limited to a few channels in the free version). ![]() Please suggest options available to me for overlaying data with the video from go pro which can provide good post processing and analysis as well. The analysis tool in the RCP app sucks.Ĭurrently I am using the dashboard screens in the RCP app while driving like the predictive lap timer. I have a RCP MK3 and a go pro hero 3+ installed in my track car(NA SM).
0 Comments
Leave a Reply. |